La solution alternative anti-TDP : DIY de nicotine avec nicoboost


Astuces & Conseils
04/02/2018 reads1926

The electronic cigaretteis in danger! This is how the vapers took the new regulation on the TDP or the law on tobacco products. Real stroke of the club on the nicotine vapes, we will love the aromas but without the essential ingredient of the liquid is lost. European legislation only urges e-liquid to put nicotine in flasks prepared by manufacturers, and limits by this new restriction of January 2017 nicotine solutions to 10 ml, which is not very convincing for its mission weaning. If we start from the fact that a big smoker inhales in general 15 to 18mg of nicotine, we can affirm that this small authorized dose does not align at all with this dependence. How to do ? Thanks to the nicotine boosters like Nicoboost, alternatives are possible because of the composition which can be up to an amount of 20 mg in a 10 ml solution. The whole thing is knowing how to calculate this value according to the general volume of the liquid.

Why did the law change its mind?

Before January 2007, the European Union acted as a spectator on the amount of nicotine ingested by vapers. As a substitute for cigarettes, there was nothing to suggest an evolution of a new addiction that could reach the same level of traditional tobacco. Reality, however, seems to correct this view which tends towards the liberalism of consumption, with the craze for new trends and the abusive exploitation of the chemical characteristics of e-liquids.

It is then necessary to believe in the sanitary benevolence of the legislation on this question of limitation, which is not exclusive. Indeed, it is the finished products, sold in shops that are concerned by the regulations (limit the boosters to 10 ml max), which causes the vapoteurs to turn on the DIY e-liquids. The solution seems at hand with nicotine boosters that offer a fair dosage in a vial that stands at that amount determined by law.

Nicotine dosage with nicoboost

DIY and booster? How it works ?

For newcomers, this limitation should not be a brake on the use of e-cigarettes. On the contrary, it allows you to control yourself the amount of nicotine that you want to ingest. The principle is to obtain a normal neutral base (since the new regulation) to 0mg by adding a solution of nicotine approved (not exceeding 10ml). The dosage meets the needs of each without exceeding the amount that is required in the set is the general volume of the liquid. To do this, a not very obvious calculation is to undertake .... Thanks again to the legislators!

Booster vials such as Nicoboost can mix a fairly high level of nicotine in a liquid solution. If the legislation limits the concentration to 10 ml, it does not stop at that amount in relation to the level of the substance. Thus, in a capacity of 10ml, it was possible to reach 20 mg of nicotine, which is largely sufficient for large consumers. To make the calculation, we proceed to a rule of three very basic, but which must be applied to the letter under penalty of poisoning.

This is a volumetric calculation based on the ratio of the booster you bought. With nicoboost, this dosage is 20 mg for 10 ml or 2 grams per liter not mixed with the base. There are tablatures that simplify this calculation according to the dosage you want to ask. Starting from the example of an e-liquid at 12 mg / ml, which is very convenient for most vapers, with a vial of 20 mg per ml, the following calculation is used: If 10 ml is equivalent to 20 mg of nicotine, what is the ratio needed to obtain 12 mg / ml for 11? From this equivalence, the calibration procedure is carried out between the base and the quantity per volume of the booster in order to obtain a result of 450 ml of base and 600 ml of nicoboost for a final rendering of 1 liter of liquid.

When making a DIY, we do not calculate the volume in small doses but on a large scale. If you get used to synthesizing small amounts, you may lose a lot of time because the preparation is not done in a day. With the mixing of basic ingredients like PG / VG and flavors, the molecules must macerate for a while, which can range from two to several weeks. This suggestion, however, does not cover taste experiments that use DIY for taste purposes. But it remains relevant at the practical level and especially economic! The price of a DIY has almost increased compared to this new regulation so that the cost of synthetization has doubled from the ban on nicotine bases.

Nicotine dosage with nicoboost

Before we strive on this artisanal option, let us review the real motive of the law on tobacco products which, in a context of benevolence, is well thought out but poorly controlled. We particularly regret the economic flexibility of the concept that traps the price at astronomical costs, instantly disqualifying the regular bases synthesized with nicotine. You can easily reach the 200 euros with a DIY barely satisfactory for the long term. Thanks to booster nicoboost, this rise is more or less attenuated by its characteristic concentrated to 20 mg in 10 ml. In terms of prevention, it is hard to imagine a consumer to be satisfied with such an expensive solution for an average result, which does not tempt the vapers to continue in this way,

And quality control is no less affected, because despite the limitation can always exceed the dosage if relying on the thesis craft. This puts even more danger to the uninitiated who venture into overdoses and excesses.

You must be registered

Cliquez ici pour vous enregistrer

Ajouter un commentaire